Removing the Tail Lights 1). Remove the Tail Light Cover by rotating the locking pin 1/4 turn and pulling the Cover off. 2). Remove the electrical plug from the tail light by squeezing the release tabs and pulling the plug out of the tail light.
20 Comments

This article describes the installation of the Tarett Engineering rear strut mounts ( no affiliation ) shown below. Because this install was part of a suspension upgrade I had the struts already out of the car. There are many articles out there describing the strut removal process in a Cayman or Boxster if your struts are in place. Access to the top of the rear struts require a fair amount of interior trim removal. You will need an impact driver with 13/16 socket and a spring compressor for...
2 Comments

I don't know of a single Throw-Out bearing that has failed in a Cayman. I decided to replace mine because of an IMS cover leak, which required me to remove my transmission, clutch, pressure plate and flywheel. Because my car had 80,000 miles on it at the time, it seemed sensible to freshen up the clutch package, which meant a new throw-out bearing too. Once the transmission is out, changing the Throw-Out bearing is a simple operation. 1Torque Values Fastener LocationDescriptionTool...
6 Comments

What??? A torque converter in a Porsche you say?! Well I have one of those and all the Porsche dealer service techs I've talked to claim that the ATF fluid in the tiptronic transmission is a "lifetime" fluid and the flush interval/filter change is 108K miles or 12 years whichever comes first. Now I track my cayman and I'm a bit skeptical of the lifetime quality of this fluid since oil/lubricants break down eventually owing to heat right? Also, during my online research I found that the same...
17 Comments

You may have heard how much fun, and possibly addictive, our Drivers Education program can be and have decided to give it a try. I’ve recently returned to the track after an extended absence and in conversations with other students have found that a better understanding of tire pressure could be helpful. Our Drivers Ed manual addresses various brake fluids and pads but I have added some detail about specific fluids and boiling points as well as some pad choice considerations. 4 Tire...

This article discusses the installation of Torque Solutions sport trans axle mounts into my 2007 Cayman 2.7L. The sport mounts keep the trans axle from moving around as much as the stock mounts and tightens up the handling of the car. The down side is that more NVH is introduced into the cabin. I am pleased to report the increase is tolerable and no where near the NVH the sport engine mount introduced into the cabin. You sense more of what the engine is doing on deceleration and various RPMs....
5 Comments

IMPORTANT NOTICE!: The US National Highway Traffic Safety Administration (NHTSA) has done extensive research and found that Tire Pressure Monitoring Systems (TPMS) reduce highway fatalities. Federal laws/codes require all passenger vehicles of <10,000 lbs. GVWR produced on or after September 1, 2007 to include TPMS and prohibits the act of disabling it. Applying the alteration contained below to a car that is registered for street use may violate Federal and/or State Motor Vehicle Safety Laws,...
2 Comments

The dreaded day arrived for me last fall. I'm writing of course about when my factory Tire Pressure Monitoring System (TPMS) sensors reached the end of their life. My car is a 2007, manufactured in June 2007, put into service in July 2007. I started seeing TPMS malfunctions (the readings all went blank while driving, then came back) in the summer of 2014. So I got about 7 years, 80,000 miles out of my sensors before they went kaput. This is pretty much in line with the 6-8 years that other...
84 Comments

This article describes the installation of a trans axle oil cooler onto my 2007 Cayman 5 speed. I was inspired by Al Norton's article on RENNTRACK.com where he added a water to transmission oil cooler to his 996 Turbo. It is reversible ( no drilling of the transaxle case ). The trans axle oil cooler is a longevity modification for track operation since our Cayman trans axles are bathed in heat from both the engine and exhaust system. The system consists of an air to oil cooler, oil pump,...
14 Comments

UPDATE 2 from Vision Motorsports: Dwain replied to my question about trans axle temperature ranges to worry about: his response was, “220 is ok. 250 is getting hot. 275, I would start to be concerned.” UPDATE: I have some trans axle temp data from my recent visit to Sebring. On the drive over, 140 miles at 55 - 65 MPH, ambient air 90 F, the trans axle oil reached 150 F. The first day of the DE air temp was 80 F and I was re-learning the track the trans axle oil reached 190 F. On the...

Shown on 5 speed 987.1. I cut a 1 3/4 inch access hole in the plate under the trans axle to easily get to the drain plug. The other thing to note is the 6 speed trans axle gets filled to the bottom of the fill port while the 5 speed transmission requires the level to be diabolically set lower than the fill port by 11 mm. The five speed drain plug requires a special 16 mm triple square anti tamper socket I got from Pelican Parts. The six speed drain plugs are more rational, using 10 mm hex...
11 Comments

Changing the transmission oil in a Cayman will keep its transmission shifting nicely and will prolong its life. Porsche recommends replacing the transmission oil at 108,000 miles or at 12 years of age, and I think it goes without saying that tracked cars should see a fluid replacement sooner than recommended. The transmission doesn't have a filtration system, so this is an area where clean oil can go a long way. Check out this discussion to learn why regular gear oil changes are a good idea,...
24 Comments

If you had told me back in 2007, when I took delivery of my Cayman S, that I'd some day be taking the transmission out of it I'd probably think you were crazy. I broke a lot of transmissions when I was a kid, but I've learned to respect my transmissions since then. As fate would have it, my car developed an oil leak that necessitated the removal of mine. Removing the transmission from one of these cars isn't as hard as you'd expect by I wouldn't call it easy either. There are a couple of...
31 Comments

This is just a summary of what consolidated, FT and L8Apx have done. :thanks: First thing first, disconnect the battery and leave the trunk and hatch open. Leave them open until you are done with the DME. Background information, I am using Traqmate complete kit and Traqdata II. E6-RPM green/blue into RPM port D16-TPS violet into A0 port
33 Comments