Removing the Cargo Bar and Trim 1. Slide the Cargo Bar caps up the Cargo Bar 2. Remove the two 8mm 12 point bolts and Cargo Bar

The rear trunk interior panels are all soft panels pressed into place like a 3D jigsaw puzzle. Removal is easy and requires few tools. There is a particular order in which the panels must be removed and installed. Removing the Rear Trunk Interior Panels: 1. Remove both Tail Light housing covers by rotating their fastening clips 90 degrees and pulling the covers out. 2. Insert your hand over the back of the trunk side panels. Grip them firmly and pull up and out. The whole...
18 Comments

Removing a 987 door panel is a pretty straight forward operation that can be done with basic tools and mechanical skills. 4 The door panel is held to the door by 5 T-30 Torx screws and 9 friction clips. The screws are hidden in the following locations: To access the screws, you first need to removes a few trim panels from the door. Let's start with the mirror trim. The mirror trim is held in my two friction clips on it's bottom, and a slide connection on the tip. 4
22 Comments

Replacing the Cabin Air Filter (also referred to as the Pollen Filter) is possibly the easiest maintenance task to perform on a Cayman. I'll demonstrate this task on my 2007 Cayman S. There are aftermarket filters available, but I like to use OE parts for my Porsche. The part number of the factory Porsche filter is 997.571.229.01. It's available at any Porsche parts department. I usually keep one on hand. Once you've obtained an OE filter or suitable replacement, you're ready to...
51 Comments

Changing the oil and filter on a Cayman is actually very easy, but slightly different than other oil changes you may have performed. There are a few specialty tools I would recommend you obtain before tackling this maintenance task. With a couple of tips and traps in mind even the most novice mechanic can handle this job. 1Torque Values Fastener LocationDescriptionTool SizeTorque ValueDrain Plug18mm Aluminum Drain Plug8mm Hex Driver37 ft.lb.Oil FilterPlastic Filter Housing74mm Oil...
168 Comments

Removing the Exhaust System (Catback) 1 Torque Values Fastener LocationDescriptionTool SizeTorque ValueExhaust Flange NutsM8 Nut (x6) (Replace with Stainless Steel)13mm Socket17 ft.lb.Rear Exhaust to Hanger8mm Bolts and M8 Lock Nuts (x4)13mm Socket17 ft.lb.Exhaust Hanger Clamps8mm Bolts and M8 Lock Nuts (x8)13mm Socket17 ft.lb. 1 1). Place wheel chocks in front of and behind each front wheel. 2). Jack up both the right and left rear wheels of the car. Use jack stands to ensure...
47 Comments

1). Remove the right side dash trim panel by gently prying outward from the front with a panel tool, then rotating it to the right. 2). Remove the right side front trim piece by prying forward with a suitable panel tool. 3). Remove right side center console cover. 4). Remove the two screws that hold the cup holder assembly in place and remove the cup holder assembly.
13 Comments