|
Articles |
Jim987 09-24-2016 09:01 AM
This article documents my installation of a complete data logging system in my Cayman S. I have chosen the AiM system not only because offers integration of ECU data and GPS data and a full software suit to configure and analyse it, but also coupling with their SmartyCam HD you get full integration of that data into a synchronized video without post production. You can watch your video with already integrated data on your laptop computer directly following an ontrack session. Here are the AiM...
22 Comments
Voyager6 04-20-2016 10:47 PM
Attached is a PDF describing how I removed my rocker panels, drilled for the GT4 vent covers and installed them successfully.
Enjoy
V6
5 Comments
Rob VN 09-12-2015 01:18 PM
The Air Oil Separator (AOS) operates to return oil that was mixed with air from the cam covers and return it to the crankcase. It has two inlet pipes, one from each cam cover and a bottom hose where the oil returns to the crankcase. This articles shows the photos taken to remove the AOS from a 2007 Base Cayman.
Remove the engine cover.
Jack up the car and remove the right rear wheel.
Remove the tie wrap on the wiring harness near the right hand hose connection.
Squeeze the upper...
18 Comments
greenfrog 08-28-2015 10:55 PM
The greenfrog (Cayman R) is hitting 222F (coolant) and 252F (oil) at VIR on a 90F+ day, so it's time to add some more cooling. The center radiator installation is well documented and straight forward. Flushing the whole cooling system is much messy and requires special tool (UView Airlift 550000) to refill. In addition there are some differences between 987.1 and 987.2 water pumps.
Here are some of the articles and forum threads I researched:
...
17 Comments
Boiler Inspector 08-02-2015 11:00 AM
This article shows you how to remove the front bumper cover. Why might you need to remove the front bumper cover? Several reasons come to mind, such as installation of third center mounted radiator, getting your front bumper repainted, or the reason for this article, cleaning out the debris from the radiators as a matter of routine maintenance.
Here are the tools necessary for this evolution:
1/4" drive ratchet
T-30 socket & ratchet or L-shaped wrench
T-25 socket & ratchet or L-shaped...
papa987 07-13-2015 08:50 PM
Vehicle: 2006 Cayman S
Why this system? I wanted a valved system with a bit deeper growl, with a richer sound going through the gears and the gurgle when decelerating. I also wanted no/minimal drone during cruising and a good looking, high quality construction and finish. This system allows me to enter/leave the neighborhood without waking everyone as I head off to cars and coffee or the Blue Ridge Mountains, but when switched to the louder mode, sounds very exotic and rewarding,...
3 Comments
greenfrog 06-23-2015 11:07 PM
981 Boxster/Cayman uses closed-back front calipers, which must be removed to change front brake pads. It's not a difficult task, but a few tips with pictures will hopefully make it even easier.
CAUTION:
1. Do not stress the hard metal brake line when moving the caliper around
2. Properly torque the brake caliper screw is crucial. Over torque it and you risk pulling the thread out of the aluminum wheel carrier.
3. Caliper screws are one-time use. Always replace with new ones. Never...
26 Comments
tdweldercs 05-11-2015 05:06 PM
P0455 error, leak inevaporative system
2006 Cayman S
There is a lot of informationfor this error code for earlier Boxsters and other models that focus on ventline valve near the fuel filler neck and/or vent lines at the charcoalcanister (carbon canister), but, unfortunately, most of this information didnot apply to my car.Since I could notfind this information when I searched here before, I thought I would do a shortwrite-up for other Porsche novices.
I am new to Porsches in general...
6 Comments
Gator Bite 04-09-2015 09:22 AM
The dreaded day arrived for me last fall. I'm writing of course about when my factory Tire Pressure Monitoring System (TPMS) sensors reached the end of their life. My car is a 2007, manufactured in June 2007, put into service in July 2007. I started seeing TPMS malfunctions (the readings all went blank while driving, then came back) in the summer of 2014. So I got about 7 years, 80,000 miles out of my sensors before they went kaput. This is pretty much in line with the 6-8 years that other...
84 Comments
Gator Bite 04-07-2015 01:22 PM
If you ever have to run a wire to the back of a Cayman, you'll need to remove the Driver Side Sill Plate. I had to do so to run a wire for my Oil Pressure Gauge and I learned that unlike most cars where that plate is held down with just plastic friction pins, the sill plate on a Cayman is rock solid. It's held in with two rather substantial bolts. If you need to remove yours, you'll want to read on.
1Removal Procedure
1). There are two plastic plugs in the side of the sill plate between...
8 Comments
|
|
|
All times are GMT -4. The time now is 04:29 PM.