|
Articles |
dhudso01 05-27-2013 05:12 PM
When I changed my clutch and was putting everything back together, I found that my driver’s side shift linkage did not snap onto the ball on the trans like it should. It felt like it was barely attached.
Upon inspection, I found a crack in the plastic ball socket:
So I zip tied it to the trans shifter bracket through the spaces between the hard plastic frame and the soft filler plastic. It held fine for about 1,000 miles, while I comptemplated the purchase of all new shifter cables for...
1 Comments
|
|
|
All times are GMT -4. The time now is 08:13 PM.